Roof Replacement in Portland, OR

In August 2025, French Roofing replaced the roofs on a home and its garage in Portland, OR. The crew tore off three layers of old roofing down to the deck, covered the spaced board sheathing with new half inch CDX plywood, and installed new CertainTeed Landmark architectural shingles over synthetic underlayment.

New gray CertainTeed Landmark architectural shingles running up to a brick chimney on a home in Portland, OR
The finished roof, up against the chimney.
New gray architectural shingles and ridge cap meeting at a brick chimney, with new roof vents on a home in Portland, OR
New shingles, ridge cap and roof vents.
Finished slope of new gray architectural shingles with a roof vent and pipe boot, above a backyard in Portland, OR
Another finished slope, with a new vent and pipe boot.
Synthetic underlayment going down over the roof deck, with plywood stacked on top, during the roof replacement in Portland, OR
Underlayment going down over the deck.
Attic view of old spaced board sheathing, with the underside of the old roofing showing through the gaps, in Portland, OR
Before: the old spaced board sheathing, seen from inside.

What we did

  • Tore off three layers of old roofing down to the deck on the house and garage
  • Installed half inch CDX plywood over the spaced board (skip sheathed) areas
  • Laid Safeguard 30 synthetic underlayment over the deck
  • Installed new CertainTeed Landmark architectural shingles with new drip edge, wall flashing, ridge cap, roof vents and pipe boots
  • Cleaned up and ran a magnet over the yard for nails

This one had three layers of roofing stacked up, and under them the deck was spaced boards with gaps between them, which you can see from inside in the photo below. All three layers came off, the open areas got new plywood so the shingles have a solid deck to sit on, and the new underlayment and shingles went on from there.

Roof Replacement in Portland: questions

Can you take off more than one layer of old roofing?

Yes. This Portland roof had three layers, and all three came off down to the deck before anything new went on.

What is skip sheathing, and can shingles go over it?

Skip sheathing is roof boards laid with gaps between them. Shingles need a solid deck, so on this job the crew covered those areas with new half inch CDX plywood before the underlayment and shingles went on.

More projects

See all past projects →

Need roof replacement work in Portland?

Get a free roof assessment and an honest answer about what your roof needs.